Kia Cee'd: Dual Clutch Transmission Control System / Clutch Actuator Motor 1 (Odd Gear) Repair procedures

Kia Cee'd JD Service Manual / Dual Clutch Transmission(DCT) System / Dual Clutch Transmission Control System / Clutch Actuator Motor 1 (Odd Gear) Repair procedures

Inspection

1.	Turn off the ignition switch.

2.	Disconnect the clutch motor connector (A).

3.	Measure the resistance on the clutch motor terminal.

4.	Refer to the specifications and check that the measured resistance is as specified. (Refer to Clutch Actuator Motor 1 - "Specification")

Removal

1.	Turn off the ignition switch and then disconnect the battery (-) cable.

2.	Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air cleaner")

3.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

4.	Remove the ECM. (Refer to Fuel System - "Engine Control Module (ECM)")

5.	Disconnect the clutch actuator motor connector (A).

Loosen the mounting screw, and then remove the clutch actuator motor (A).

Tightening Torque :

4.4 ~ 5.4 N.m (0.45 ~ 0.55 kgf.m, 3.3 ~ 4.0 lb-ft)

Installation

Install in the reverse order of removal.

Clutch actuator spline (A) with grease before installation.

Specified grease [CSG-101M (0.1ml)]

Clutch Actuator Motor 1 (Odd Gear) Schematic diagrams

Schematic Diagrams ...

Clutch Actuator Motor 2 (Even Gear) Description and operation

Description The clutch actuator motor is mounted on the Dual Clutch Transmission(DCT). The clutch actuator motor comprises an actuator motor that controls the odd clutch and a ...

Other information:

Kia Cee'd JD Service Manual: Thermostat Repair procedures
Removal Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. 1. Drain engine coolant so that its level would be under the therm ...

Kia Cee'd JD Service Manual: Auto Defogging Sensor Description and operation
Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog b ...