Kia Cee'd: Manual Transaxle Control System / Control Cable Repair procedures

Kia Cee'd JD Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Cable Repair procedures

Removal

1.	Move the shift lever to 4th gear.

2.	Remove the air duct and the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

3.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

Remove the control cable.

(1)	Remove the control cable from the control shaft after removing the snap pins (A).

(2)	Remove the control cable (B) from the bracket (C).

5.	Remove the gear boots (A) and then remove the shift lever knob (B) by rotating counter-clockwise.

6.	Remove the floor console assembly. (Refer to Body - " Floor Console")

7.	Remove the select cable (A) from the shift lever after removing the snap pin.

8.	Remove the shift cable (B) after removing the clip (A).

9.	Remove the cable sockets (A) from the shift lever.

10.	Remove the crash pad and cowl cross bar. (Refer to Body - "Cowl Cross Bar Assembly")

11.	Remove the heater unit. (Refer to Heating,Ventilation, Air Conditioning - "Heater Unit")

12.	Remove the retainer (A) after loosen the nut (B).

13.	Remove the control cable into the cabin room side.

Installation

Install the cable retainer (A).

Tightening torque :

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

2.	Install the heater unit. (Refer to Heating,Ventilation, Air Conditioning - "Heater Unit")

3.	Install the crash pad and cowl cross bar. (Refer to Body - "Cowl Cross Bar Assembly")

4.	Install the control cable soket (A).

5.	Install the shift cable ( B) to the shift lever after intalling the snap pin (A).

6.	Insert the snap pin after installing the select cable (A) to the shift lever.

7.	Install the floor console assembly. (Refer to Body - "Floor Console")

8.	Install the boots (A) to the console after Installing the knob (B) by rotating clockwise.

Install the control cable.

(1)	Check that the shift lever and control shaft are placed in the "4th" position.

(2)	Install the control cable to the cable bracket.

(3)	After pulling the holder (A) in the direction of the "P", pull the lock (B) in the direction of the "F".

(4)	Push the lock (C) after installing the control cable to the control shaft.

(5)	Insert the snap pin (A).

10.	Install the battery and battery tray. (Refer to Engine Electrical System - "Battery")

11.	Install the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

Control Cable Components and components location

Components 1. Knob & Boots 2. Shift lever assembly 3. Shift cable 4. Select cable 5. Control cable retainer ...

Control Shaft Complete Components and components location

Components Location 1. Control Shaft Complete ...

Other information:

Kia Cee'd JD Owners Manual: Driving information mode
This mode indicates 3 kinds of driving Information. All stored driving information (except odometer, distance to empty and instant fuel economy) resets if the battery is disconnected. 1. Distance to empty (km or mi.) This mode indicates the estimated distance the vehicle can be driven w ...

Kia Cee'd JD Service Manual: General information
Warning And Caution Labels 1. Fan caution 2. Radiator cap caution 3. Battery caution Battery Caution Label Warning / Caution Label (Cont'd) A. Keep lighted cigarettes and all other flames or sparks aw ...