Kia Cee'd: Engine Control System / ETC (Electronic Throttle Control) System Repair procedures

Kia Cee'd JD Service Manual / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Repair procedures

Inspection

Throttle Position Sensor (TPS)

1.	Connect the GDS on the Data Link Connector (DLC).

Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.

Specification: Refer to “Specification”

ETC Motor

1.	Turn the ignition switch OFF.

2.	Disconnect the ETC module connector.

3.	Measure resistance between the ETC module terminals 1 and 2.

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the resonator and the air intake hose. (Refer to Engine Mechanical System - "Air Cleaner")

3.	Disconnect the ETC module connector (A).

4.	Disconnect the coolant hoses (A).

5.	Remove the installation bolts, and then remove the ETC module (A) from the engine.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

Installation is reverse of removal.

Electronic throttle body Installation bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Adjustment

ETC module learning procedure

When installing new ETC module or re-installing it, ETC module learning procedure must be performed.

1.	Hold the ignition key or the start button at th IG ON position during 5 seconds.

2.	Turn ignition swich OFF and then start the engine.

DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module.

ETC (Electronic Throttle Control) System Schematic diagrams

Circuit Diagram ...

Manifold Absolute Pressure Sensor (MAPS) Description and operation

Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfer ...

Other information:

Kia Cee'd JD Service Manual: Components and components location
Component Location Item Description SPAS SPAS unit (ECU) • Calculate the parking trace of wheels • Calculate and ask the demand angle to MDPS • Warning and detect ...

Kia Cee'd JD Owners Manual: Highway driving
Tires Adjust the tire inflation pressures to specification. Low tire inflation pressures will result in overheating and possible failure of the tires. Avoid using worn or damaged tires which may result in reduced traction or tire failure. ✽ NOTICE Never exceed the maximum tire inflatio ...