Kia Cee'd: Seat belt restraint system / Lap/shoulder belt
Height adjustment (5 Door and Wagon)
■ Front seat
You can adjust the height of the shoulder belt anchor to one of 4 positions for maximum comfort and safety.
The height of the adjusting seat belt should not be too close to your neck.You will not be getting the most effective protection. The shoulder portion should be adjusted so that it lies across your chest and midway over your shoulder near the door and not your neck.
To adjust the height of the seat belt anchor, lower or raise the height adjuster into an appropriate position.
To raise the height adjuster, pull it up (1). To lower it, push it down (3) while pressing the height adjuster button (2).
Release the button to lock the anchor into position. Try sliding the height adjuster to make sure that it has locked into position.
Shoulder belt extension guide (For 3-door vehicle only)
You can adjust the position of the shoulder belt extension guide for easier access to the shoulder belt.
- Set the belt extension guide to the position (1~2) when using the seat belt.
- Set the belt extension guide to the position (3) when getting in or getting out of the rear seat.
WARNING
- Verify the shoulder belt anchor is locked into position at the appropriate height. Never position the shoulder belt across your neck or face. Improperly positioned seat belts can cause serious injuries in an accident.
- Failure to replace seat belts after an accident could leave you with damaged seat belts that will not provide protection in the event of another collision leading to personal injury or death. Replace your seat belts after being in an accident as soon as possible.
To fasten your seat belt:
■ Rear center seat belt (if equipped)
To fasten your seat belt, pull it out of the retractor and insert the metal tab (1) into the buckle (2). There will be an audible "click" when the tab locks into the buckle.
The seat belt automatically adjusts to the proper length only after the lap belt portion is adjusted manually so that it fits snugly around your hips. If you lean forward in a slow, easy motion, the belt will extend and let you move around. If there is a sudden stop or impact, however, the belt will lock into position. It will also lock if you try to lean forward too quickly.
CAUTION
When using the rear center seat belt, the buckle with the “CENTER” mark must be used.
✽ NOTICE
If you are not able to pull out the seat belt from the retractor, firmly pull the belt out and release it. Then you will be able to pull the belt out smoothly.
WARNING
You should place the lap belt portion as low as possible and snugly across your hips, not on your waist. If the lap belt is located too high on your waist, it may increase the chance of injury in the event of a collision. Both arms should not be under or over the belt. Rather, one should be over and the other under, as shown in the illustration.
Never wear the seat belt under the arm near the door.
To release the seat belt:
The seat belt is released by pressing the release button (A) in the locking buckle. When it is released, the belt should automatically draw back into the retractor.
If this does not happen, check the belt to be sure it is not twisted, then try again.
Seat belt warning
Driver’s seat belt warning (1) As a reminder to the driver, the seat belt warning light will illuminate for approximately 6 seconds each time you turn the ignition switch ON regardless of b ...Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat belts. The purpose of the pre-tensioner is to make sure that the seat belts fit tightly against the occupant's ...Other information:
Kia Cee'd JD Owners Manual: Clothes hanger
CAUTION
Do not hang heavy clothes, since
those may damage the hook.
Be careful when opening and closing
the doors. Clothes, etc. may
get caught between the door gap.
WARNING
Do not hang other objects such as
hangers or hard objects except
clothes. Also, do not put heavy,
...
Kia Cee'd JD Owners Manual: Washer fluid
Checking the washer fluid level
Check the fluid level in the washer fluid
reservoir and add fluid if necessary.
Plain water may be used if washer fluid is
not available. However, use washer solvent
with antifreeze characteristics in
cold climates to prevent freezing.
WARNING - Coolant
...