Kia Cee'd: Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Repair procedures
| 1. |
Connect the GDS on the Data Link Connector (DLC).
|
| 2. |
Measure the output voltage of the MAPS at idle and IG ON.
|
Specification: Refer to "Specification"
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
|
| 2. |
Disconnect the manifold absolute pressure sensor connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the sensor from the
surge tank.
|
| • |
Install the component with the specified torques.
|
| • |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
| • |
Insert the sensor in the installation hole and be careful not
to damage.
|
|
| 1. |
Installation is reverse of removal.
|
Manifold absolute pressure sensor installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
Description
Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure
Sensor and detects the intake air temperature.
To calculate precise air quantity, ...
Other information:
Kia Cee'd JD Owners Manual: If the engine overheats
If your temperature gauge indicates overheating,
you will experience a loss of
power, or hear loud pinging or knocking,
the engine is probably too hot. If this happens,
you should:
1. Pull off the road and stop as soon as it
is safe to do so.
2. Place the shift lever in P (automatic
tr ...
Kia Cee'd JD Owners Manual: Checking the tire inflation pressure
1. After driving approximately 7~10
km (4~6 miles or about 10 min),
stop at a safety location.
2. Connect the filling hose (2) of the
compressor directly to the tire
valve.
3. Plug the compressor power cord
into the vehicle power outlet.
4. Adjust the tire inflation pressure to
the ...
Manifold Absolute Pressure Sensor (MAPS) Schematic diagrams
Intake Air Temperature Sensor (IATS) Description and operation