Kia Cee'd: Clutch Switch / Repair procedures
Signal Circuit Inspection
| 1. |
Check clutch switch pull-up voltage
| (1) |
IG KEY "OFF", ENGINE "OFF".
|
| (2) |
Disconnect clutch switch connector.
|
| (4) |
Measure the voltage between signal terminal of clutch switch
harness connector and chassis ground.
|
Specification : 11.5V ~ 13.0V
|
|
|
| 2. |
Check open in clutch switch signal circuit
| (1) |
IG KEY "OFF", ENGINE "OFF".
|
| (2) |
Disconnect clutch switch connector and ECM connector.
|
| (3) |
Check continuity between signal terminal of clutch switch harness
connector and ECM harness connector.
|
Specification : Continuity ( below 1.0Ω )
|
|
|
Ground Circuit inspection
| 1. |
IG KEY "OFF", ENGINE "OFF".
|
| 2. |
Disconnect clutch switch connector.
|
| 3. |
Check continuity between clutch switch connector terminal 1 and chassis
ground.
|
Specification : Continuity ( below 1.0Ω )
|
|
Component Inspection
| 1. |
Remove the clutch switch.
|
| 2. |
Push the clutch switch in the direction of the arrow to make sure that
continuity is cut off.
|
Condition
|
Clutch Pedal pressed
|
Clutch Pedal Released
|
Switch Operation
|
ON (below 1.0Ω )
|
OFF ( Infinite Ω )
|
|
|
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
|
| 2. |
Disconnect clutch switch connector (A).
|
| 3. |
Remove the clutch switch (B) by loosening a nut (A).
|
| 1. |
Install in the reverse order of removal.
|
| 2. |
Adjust the clutch switch.
| (1) |
Adjust the gab by rotating the adjust nut (A) to satisfy the
standard gap range.
|
Standard gap range:
0.5 ~ 1.0 mm (0.0197 ~ 0.0394 in.)
|
|
| (2) |
Tighten the nut (B) with the specified torque.
|
Tightening torque:
7.8 ~ 9.8 N (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
|
|
|
Specifications
Item
Specifications
Working voltage
DC
12V
Operating force
14.7 ± ...
Other information:
Kia Cee'd JD Owners Manual: Towing service
If emergency towing is necessary, we
recommend having it done by an authorized
Kia dealer or a commercial tow-truck
service. Proper lifting and towing procedures
are necessary to prevent damage
to the vehicle. The use of wheel dollies or
flatbed is recommended.
For trailer towing guid ...
Kia Cee'd JD Service Manual: ABS Control Module Repair procedures
Removal [LHD]
1.
Turn the ignition switch OFF.
2.
Pull up the lock of the HECU connector (A), and then disconnect the
connector.
3.
Remove the brake fluid from the master cylinder reservoir wi ...
Specifications