Kia Cee'd: Panoramaroof / Roller Blind Motor Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Panoramaroof / Roller Blind Motor Repair procedures

Inspection

1.	Disconnect the negative (-) battery terminal.

2.	Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly")

3.	Disconnect the connector (A).

4.	Remove the panoramaroof motor (B) after loosening 3 bolts.

Ground the terminals as below table, and check that the roller blind motor operates.

When inspecting the panoramaroof motor operation, panoramaroof motor and roller blind motor always should be connected.

Resetting The Panoramaroof

Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the Panoramaroof, you have to reset your Panoramaroof system as follows :

1.	Turn the ignition key to the ON position and then close the panoramaroof completely.

2.	Release the panoramaroof control lever.

3.	Press and hold the CLOSE button for more than 10 seconds until the panoramaroof has moved slightly.

4.	Release the panoramaroof control lever.

Press and hold the CLOSE button once again within 3 seconds until the panoramaroof do as follows;

•	Tilt → Slide Open → Slide Close Then release the lever.

6.	Reset procedure of panorama system is finished.

Protecting Motor From Overheating

In order to protect the panoramaroof motor from overheating from continuous motor operation, the panoramaroof ECU controls the Run-time and Cool-time of the motor as follows:

1.	The panoramaroof ECU detects the Run- time of motor

2.	Motor can be operated continuously for the 1st run-time (120 ± 10sec.).

3.	The continuous operation of motor stops after the 1st Run-time (120 ± 10sec.).

4.	Then Motor is not operated for the 1st Cool-time (18 ± 2sec.).

5.	Motor is operated for the 2nd Run-time (10 ± 2sec.) at the continued motor operation after 1st Cool-time (18 ± 2sec.)

6.	The continuous operation of motor stops operating after the 2nd Run-time (10 ± 2sec.)

7.	Motor is not operated for the 2nd Cool-time (18 ± 2sec.).

Motor repeats the 2nd run-time and 2nd cool-time at the continued motor operation.

–	In case that motor is not operated continuously, the run-time is increased.

–	The Run-Time of motor is initialized to "0" if the battery or fuse is reconnected after being disconnected, discharged or blown.

T1 : 120 ± 10 sec., T2 : 18 ± 2 sec.,

T3 : 10 ± 2 sec., T4 : 18 ± 2 sec.

Panoramaroof Motor Repair procedures

Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim ...

Lighting System

...

Other information:

Kia Cee'd JD Service Manual: Accelerator Pedal Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation bolt (B) and nut ...

Kia Cee'd JD Service Manual: Manifold Absolute Pressure Sensor (MAPS) Description and operation
Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional to the pressure to the ECM. By using this signal, the ECM calcul ...