Kia Rio: Adjustment
Parking Brake Lever Stroke Adjustment |
1. |
Remove the floor console.
(Refer to Body group - "Floor console")
|
2. |
Apply a coating of the specified grease to each sliding parts
(A) of the ratchet plate or the ratchet pawl.
Specified grease:
Multi purpose grease SAE J310, NLGI No.2
|
|
3. |
Install the parking brake cable adjuster, then adjust the parking
brake lever stroke by turning adjusting nut (A).
Parking brake lever stroke:
5 ~ 7 clicks (Pull the lever with 196N (20 kgf, 44 lbf))
|
After repairing the parking brake shoe, adjust the brake
shoe clearance, and then adjust the parking brake lever stroke.
(Refer to "Parking brake shoe installation")
|
4. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if necessary.
|
5. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
6. |
Install thd floor console.
(Refer to the Body group - "Floor console")
|
Parking Brake Shoe Clearance Adjustment |
Rear Drum Brake Type
1. |
Depress the brake pedal several times to set the self-adjusting
brake.
For Drum Brake type, shoe clearance is automatically adjusted
by the adjuster and adjusting lever.
|
Rear Disc Brake Type
Re-setting of the parking brake is necessary after overhauling
the caliper body, or if the brake calipers, housing, parking brake cable
or brake discs have been changed.
1. |
Remove the floor console to reach the adjusting nut.
|
2. |
Loosen the parking brake cable until both operating levers rest
in fully off position.
|
3. |
Bring the brake pads in their operating position by pressing the
brake pedal down several times until there is resistance.
|
4. |
Tension the parking brake cable by tightening the adjusting nut,
until the operating levers on both calipers lift from the stop, up to
a distance of (A) between operating lever (B) and stopper (C).
Distance (A): Max.
1.5 mm (0.06 in)
|
|
5. |
Parking brake lever in the car must be in fully loosened position.
|
6. |
If the handbrake cables where changed, actuate the parking brake
a few times with maximum force to stretch the parking brake cables,
and then control adjusting as above.
|
7. |
Check the wheels of their free operation.
|
8. |
Install the floor console.
|
9. |
Test drive.
|
Rear Disc Brake Type
1.
Install the parking brake cable.
2.
Install the parking brake cable (A), and then install the clip
(B ...
See also:
Sunroof Components
1 . Glass panel assembly
2 . Glass panel
3 . Reinforcement glass
4 . Encapsulated glass panel
5 . Wind deflector net assembly
6 . Wind deflector beam
7 . Plate cover [RH] ...
Specifications
Item
Specification
Type
Electric Power Steering System
Steering gear
Type
Rack & Pinion
Rack stroke
144mm (5.6693 i ...
Anchor Pretensioner (APT) Components
...