Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: BJ Boot Replacement - Driveshaft Assembly - Driveshaft and axle - Kia Rio UB 2012-2020 Service ManualKia Rio: BJ Boot Replacement

1.
Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”)
2.
Remove the TJ joint assembly. (Refer to DS group - “TJ Joint”)
3.
Remove the Dynamic damper. (Refer to DS group - “Dynamic Damper”)
4.
Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).


5.
Remove the BJ boot.
6.
Install in the reverse order of removal.

     
Do not disassemble the BJ assembly.
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.
BJ Boot Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...
Rear Axle Assembly
...
See also:

Hood switch Removal
1. After loosening the mounting bolts and connector, then remove the hood switch (A). ...

Audio Unit Removal
   • Take care not to scratch the center fascia panel and related parts. ...

Condenser Inspection
1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdrive ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts