Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Climate control air filter - Manual climate control system - Features of your vehicle - Kia Rio UB 2012-2020 Owners ManualKia Rio: Climate control air filter

The climate control air filter installed behind the glove box filters the dust or other pollutants that come into the vehicle from the outside through the heating and air conditioning system.

If dust or other pollutants accumulate in the filter over a period of time, the air flow from the air vents may decrease, resulting in moisture accumulation on the inside of the windshield even when the outside (fresh) air position is selected. If this happens, have the climate control air filter replaced by an authorized Kia dealer.

✽ NOTICE

Checking the amount of air conditioner refrigerant and compressor lubricant

When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a negative influence on the air conditioning system.

Therefore, if abnormal operation is found, have the system inspected by an authorized Kia dealer.

WARNING

Because the refrigerant is at very high pressure, the air conditioning system


Because the refrigerant is at very high pressure, the air conditioning system should only be serviced by trained and certified technicians. It is important that the correct type and amount of oil and refrigerant is used, otherwise damage to the vehicle and personal injury may occur.

The air conditioning system should be serviced by an authorized Kia dealer.

Instrument panel vents
The outlet vents can be opened or closed separately using the thumbwheel. Also, you can adjust the direction of air delivered from these vents using the vent control lever as shown. Temperature ...
Windshield defrosting and defogging
WARNING - Windshield heating Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and the windshield could ...
See also:

Removal
1. Turn ignition switch OFF, and disconnect the negative (-) battery cable. 2. Remove the battery and ECM. (Refer to Engine Electr ...

Inspection
Camshaft Assembly 1. Inspect the cam height. Using a micrometer, measure the cam height. Cam height Intake : 44.15mm (1.7382in ...

Power Mosfet (FATC) Inspection
1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of blower motor. 3. ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts