Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Cruise Control Switch: Inspection - Cruise Control System - Engine Electrical System - Kia Rio UB 2012-2020 Service ManualKia Rio: Cruise Control Switch: Inspection

Measuring Resistance
1.
Disconnect the cruise control switch connector from the control switch.
2.
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Function switch
 Terminal
 Resistance
CANCEL
 3 - 4
 180 Ω ± 5%
SET/–
 3 - 4
 330Ω ± 5%
RES/+
 3 - 4
 550Ω ± 5%
ON/OFF
 3 - 4
 880Ω ± 5%
SLD
 3 - 4
 1.44kΩ ± 5%

3.
If not within specification, replace switch.
Measuring Voltage
1.
Connect the cruise control switch connector to the control switch.
2.
Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).
Function switch
 Terminal
 Voltage
CANCEL
 3 - 4
 0.76 ± 0.1V
SET/–
 3 - 4
 1.24 ± 0.15V
RES/+
 3 - 4
 1.77 ± 0.2V
ON/OFF
 3 - 4
 2.34 ± 0.1V
SLD
 3 - 4
 3.0 ± 0.22V

3.
If not within specification, inspect the control switch resistance.
The measuring resistance value is not within specification, replace the switch and measure the voltage again.
4.
If resistance is OK but, measuring voltage is not within specification, inspect the wiring harness and connectors between the switch and the ECM.`
Cruise Control Switch: Installation
1. Install in the reverse order of removal. ...
Emission Control System
...
See also:

Adjustment
ETC module learning procedure When installing new ETC module or re-installing it, ETC module learning procedure must be performed. 1. Hold the ignition key o ...

Windshield Glass Components
1. Windshield glass 2. Windshield glass moulding ...

Schematic Diagrams
Circuit Diagram (1) Circuit Diagram (2) Circuit Diagram (3) SRSCM Connector Terminal Pin Function (Connector A) Pin Function (Connector B) ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts