Kia Rio: Engine Oil: Inspection
|
1. |
Check the engine oil quality.
Check the oil deterioration, entry of water, discoloring of thinning.
If the quality is visibly poor, replace the oil.
|
|
2. |
Check the engine oil level.
After engine warm up stop the engine wait 5 minutes then check
the oil level. Oil level should be between the "L" and "F" marks on
the dipstick. If low check for leakage and add oil up to the "F" mark.
Do not fill with engine oil above the "F" mark.
|
Selection Of Engine Oil
Recommendation of oil classification : API SM, ILSAC GF-4, ACEA A5 (API
SL/ ILSAC GF-3/ ACEA A3 class oil can be used if the recommended oil is not
available)
SAE viscosity grade : Refer to the recommended SAE viscosity number
For best performance and maximum protection of all types of operation,
select only those lubricants which :
| 1.
Satisfy the requirement of the API or ILSAC classification.
|
| 2.
Have proper SAE grade number for expected ambient temperature
range.
|
| 3.
Lubricants that do not have both an SAE grade number and
API or ILSAC service classification on the container should
not be used.
|
•
Prolonged and repeated contact with mineral oil will result
in the removal of natural ...
See also:
Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pillar nearby (LH ...
Rear Wheel Alignment
When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always p ...
Seat Belt Buckle Switch (BS) Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front seat assembly.
...
Engine Oil: Oil And Filter Replacement
