Kia Rio: Engine Oil: Oil And Filter Replacement
| •
Prolonged and repeated contact with mineral oil will result
in the removal of natural fats from the skin, leading to dryness,
irritation and dermatitis. In addition, used engine oil contains
potentially harmful contaminants which may cause skin cancer.
|
| •
Exercise caution in order to minimize the length and frequency
of contact of your skin to used oil. Wear protective clothing
and gloves. Wash your skin thoroughly with soap and water, or
use water-less hand cleaner, to remove any used engine oil.
Do not use gasoline, thinners, or solvents.
|
| •
In order to preserve the environment, used oil and used
oil filter must be disposed of only at designated disposal sites.
|
1. |
Drain the engine oil.
|
(1) |
Remove the oil filler cap.
|
(2) |
Remove the oil drain plug, and drain the oil into a container.
|
2. |
Replace the oil filter.
|
(1) |
Remove the oil filter.
|
(2) |
Check and clean the oil filter installation surface.
|
(3) |
Check the part number of the new oil filter is as same
as old one.
|
(4) |
Apply clean engine oil to the gasket of a new oil filter.
|
(5) |
Lightly screw the oil filter into place, and tighten it
until the gasket contacts the seat.
|
(6) |
Tighten it with the torque below.
Tightening torque :
11.8 ~ 15.7N.m (1.2 ~ 1.6kgf.m, 8.7 ~ 11.6lb-ft)
|
|
3. |
Refill with engine oil.
|
(1) |
Clean and install the oil drain plug with a new gasket.
Tightening torque :
34.3 ~ 44.1N.m (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)
|
|
(2) |
Fill with fresh engine oil.
Capacity
Total : 3.7L (3.91US qt, 3.25lmp qt)
Oil pan : 3.0L (3.17US qt, 2.64lmp qt)
Drain and refill in cluding oil filter :
3.3 L (3.49US qt, 2.90lmp qt)
|
|
(3) |
Install the oil filler cap.
|
4. |
Start engine and check for oil leaks.
|
5. |
Recheck the engine oil level.
|
1. Timing chain cover
2. Inner roter
3. Outer roter
4. Pump cover
5. Gasket
6. Oil screen
7. Oil pan
8. Drain plug gasket
9. Oil drain plug
...
•
Prolonged and repeated contact with mineral oil will result
in the removal of natural ...
See also:
Circuit Diagram
(M/T)
(A/T)
...
Components
1. Cylinder block
2. Ladder frame
3. Crankshaft
4. Crankshaft upper bearing
5. Crankshaft lower bearing
6. Thrust bearing
7. Main bearing cap
8. Adapter plate
...
Transmitter Inspection
1.
Check that the red light flickers when the door lock or unlock
button is pressed on the transmitter.
2.
Remove the battery and check vol ...