Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Front Impact Sensor (FIS) Removal - SRSCM - Restraint - Kia Rio UB 2012-2020 Service ManualKia Rio: Front Impact Sensor (FIS) Removal


     
Removal of the airbag must be performed according to the precautions/ procedures described previously.
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front wheel guard.
(Refer to the Body group - "Exterior")
3.
Left side - Remove the air duct assembly.
Right side - Remove the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
4.
Remove the front impact sensor (B) mounting bolt.


5.
Disconnect the front impact sensor connector (A).
6.
Remove the front impact sensor.
Front Impact Sensor (FIS) Components
...
Front Impact Sensor (FIS) Installation
   • Do not turn the ignition switch ON and do not contact the battery cable while replacin ...
See also:

Component Location
1. Driver power window switch 2. Door lock switch 3. BCM (Body Control Module) 4. Front door lock actuator 5. Rear door lock actuator 6. Internal junction box ...

Compressor Oil Specification
1. The HFC-134a system requires synthetic compressor oil (PAG) whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. ...

Curtain Airbag (CAB) Module Components
...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts