Kia Rio: Front Wiper Motor Removal
1. |
Loosen the windshield wiper arm nut (A) after removing a wiper
cap (B).
|
2. |
Remove the windshield wiper arm and blade.
|
3. |
If necessary, release the wiper blade fixing clip by pulling up
and remove the wiper blade from the inside radius of wiper arm.
|
4. |
Disconnect the washer hose (A) connected to cowl top cover.
|
5. |
Remove the weather strip and the cowl top cover (B) after removing
rivets.
|
6. |
Disconnect the wiper motor connector (A) from the wiper motor
& linkage assembly.
|
7. |
Remove the windshield wiper motor and linkage assembly (B) after
removing 2 bolts.
|
8. |
Hold the wiper motor crank arm and remove the linkages (A) (B)
from the wiper motor crank arm.
Before remving the wiper motor and linkage assembly, make
sure that the linkage is stopped at auto stop position.
To install the wiper motor crank arm exactly, check that
the linkage is aligned with the crank arm in straight line and
the angle of each linkages.
Be careful not to bend the linkage.
|
9. |
Loosen 3 bolts and remove the wiper motor(A) from the wiper motor
crank arm.
|
1. Cap
2. Nut
3. Wiper arm & blade
4. Rivet
5. Cowl top cover
6. Bolt
7. Wiper motor & linkage assembly
...
1.
Install the wiper motor.
2.
Install the crank arm.
3.
Install the lower and upper linkage to the wiper motor ...
See also:
Fuel Tank Air Filter
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Lift the vehicle.
3.
...
Tire pressure monitoring system
(1) Low tire pressure telltale / TPMS malfunction indicator
Each tire, including the spare (if provided), should be checked monthly when
cold and inflated to the inflation pressure recommended by ...
Troubleshooting
Symptom
Suspect Area
Remedy (Refer to page)
Water leaks from sunroof
Dirt accumulated in drain tube
Clear dirt inside of drain
Clogged drai ...