Kia Rio: Fuel Pump Removal
1. |
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
|
2. |
Remove the rear seat [LH] (Refer to “Seat” in BD group).
|
3. |
Remove the fuel pump service cover (A).
|
4. |
Disconnect the fuel pump connector (A).
|
5. |
Disconnect the fuel feed tube quick connector (B).
|
6. |
Disconnect the fuel tank pressure sensor connector (C).
|
7. |
Disconnect the vapor tube quick-connector (D).
|
8. |
Remove the plate cover (E) after removing the installation bolts,
and then remove the fuel pump from the fuel tank.
|
1.
Installation is reverse of removal.
Fuel tank band installation
nut:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
...
1.
Installation is reverse of removal.
Fuel pump plate cover installation
bolt :
1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2.17 lb- ...
See also:
Specifications
Battery [Non-ISG type]
Item
Specification
Model type
CMF45L-BCI
Capacity [20HR/5HR] (AH)
45/36
Cold Cranking Amperage (A)
...
Overhead Console Lamp Installation
1.
Install the overhead console lamp after connecting the sunroof
switch connector and lamp connector.
2.
Install the lens after tightening ...
Anchor Pretensioner (APT) Installation
1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
...