Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Inspection - Keyless Entry And Burglar Alarm - Body Electrical System - Kia Rio UB 2012-2020 Service ManualKia Rio: Inspection

Front Door Lock Actuator and Switch
1.
Remove the front door trim.
(Refer to the Body group - Front door)
2.
Remove the front door latch.
(Refer to the Body group - Front door).
3.
Disconnect the connectors from the actuator.


4.
Check actuator operation by connecting power and ground according to the table.
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table

     
To prevent damage to the actuator, apply battery voltage only momentarily.
[without key (4Pin)]



[with key (6Pin)]]



Rear Door Lock Actuator and Switch
1.
Remove the rear door trim.
(Refer to the Body group - Rear door)
2.
Remove the rear door latch.
(Refer to the Body group - Rear door)
3.
Disconnect the connectors from the actuator.


4.
Check actuator operation by connecting power and ground according to the table.
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table

     
To prevent damage to the actuator, apply battery voltage only momentarily.



Trunk lid/ Tailgate release actuator
1.
Disconnect the negative battery terminal.
2.
Remove the rear trunk lid trim (the tailgate trim) and then remove the trunk lid switch (the tailgate switch) fromm the actuator.
[Trunk lid latch]


[Tailgate latch]


3.
Check for continuity between the terminals in each switch position according to the table.


Door switch
Remove the door switch and check for continuity between the terminals.



Door warning switch
1.
Remove the steering column upper (A) and lower (B) shrouds after removing the screws.



2.
Disconnect the 6P connector from the door warning switch.


3.
Check for continuity between the terminals in each position according to the table.


Hood Switch Inspection
1.
Remove the hood latch assembly.
(Refer to the Body group - Hood)
2.
Remove the hood switch (A) after loosening the mounting screw from hood latch.
[5 Door]


3.
Check for continuity between the terminals and ground according to the table.


Burglar Horn Inspection
1.
Remove the burglar horn (A) after removing 1 bolt and disconnect the 2P connector from the burglar horn.
[5 Door]


2.
Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2.
3.
The burglar horn should make a sound. If the burglar horn fails to make a sound replace it.
Function
Keyless Entry Function DOOR LOCK / UNLOCK are performed with remote controller. 1. Keyless entry function is performed in a state that key in switch is eliminated f ...
Transmitter Inspection
1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the battery and check vol ...
See also:

Front Strut Assembly Disassembly and Reassembly
1. Compress the coil spring with a strut spring compressor. Do not compress the spring more than necessary. 2. Loosen the lock nut. ...

Power Window Motor Circuit Diagram
...

Description
Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to control the a ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts