Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Installation - Engine And Transaxle Assembly - Engine Mechanical System - Kia Rio UB 2012-2020 Service ManualKia Rio: Installation

Installation is in the reverse order of removal.
Perform the following :
Adjust a shift cable.
Refill engine with engine oil.
Refill a transaxle with fluid.
Refill power steering fluid.
Refill a radiator and a reservoir tank with engine coolant.
Clean battery posts and cable terminals and assemble.
Inspect for fuel leakage.
-
After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
-
Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
Bleed air from the cooling system.
-
Start engine and let it run until it warms up. (until the radiator fan operates 3 or 4 times.)
-
Turn Off the engine. Check the level in the radiator, add coolant if needed. This will allow trapped air to be removed from the cooling system.
-
Put radiator cap on tightly, then run the engine again and check for leaks.
Removal
   Use fender covers to avoid damaging painted surfaces. ...
Timing System
...
See also:

Smart key
With a smart key, you can lock or unlock a door and even start the engine without inserting the key. The functions of the buttons on a smart key are similar to the remote keyless entry. (Refer ...

Remote keyless entry
...

Blower Unit Components
1. Blower Motor 2. Blower Fan 3. Clamp 4. NVH Pad 5. Connection Case 6. Cluster Ionizer (FATC only) 7. Intake Case (Left) 8. Intake Seal 9. NVH Pad 10. Intake ...

Copyright © www.kiamanual.com 2020-2021