Kia Rio: Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least thirty seconds.

Install the seat belt pretensioner with bolts (B, C).

Tightening torque:

Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.	Connect the seat belt pretensioner connector (A).

Install the upper anchor bolt.

Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

6.	Install the center pillar trim. (Refer to the Body group - "Interior trim")

7.	Install the door scuff trim. (Refer to the Body group - "Interior trim")

Insert the seat belt to the anchor pretensioner.

Make sure the lock pin is connected in properly.

9.	Reconnect the battery negative cable.

10.

After installing the seat belt pretensioner, confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal

1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the seat belt after pushin ...

Anchor Pretensioner (APT) Description

Front seat belt anchor pretensioner operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat a ...

Kia Rio: Installation

Removal

Anchor Pretensioner (APT) Description

See also: