Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Installation 
 - Specification - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2020 Service ManualKia Rio: Installation


     
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.

Electronic throttle body Installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose (Refer to I ...
Adjustment
ETC module learning procedure When installing new ETC module or re-installing it, ETC module learning procedure must be performed. 1. Hold the ignition key o ...
See also:

Measurement Point
Measurements should be taken at the center of the hole. ...

License Lamp Installation
1. Install the bulb. 2. Connect the lens and license lamp. ...

Valve Body Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Copyright © www.kiamanual.com 2020-2021