Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Intake Actuator Inspection - Blower - Heating,Ventilation, Air Conditioning - Kia Rio UB 2012-2020 Service ManualKia Rio: Intake Actuator Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 4 and grounding terminal 3.
Verify that the intake actuator operates to the recirculation position when connecting in the reverse.


1. -                 
2.                   
3. Recirculation
4. Fresh              
5. Sensor Ground
6. Feedback Signal
7. Sensor (+ 5V)

4.
Connect the intake actuator connector.
5.
Turn the ignition switch ON.
6.
Check the voltage between terminal 6 and 5.
Specification
Door position
Voltage (V)
Error detecting
Fresh
0.5
Low voltage : 0.1V or less
Recirculation
4.5
High voltage : 4.9V or more

7.
If the intake actuator is not operated well, substitute with a known-good intake actuator and check for proper operation.
8.
Replace the intake actuator if it is proved that there is a problem with it.
Intake Actuator Description
The intake actuator is located at the blower unit. It regulates the intake door by signal from control unit. Pressing the intake selection switch will shift between recirculation and fresh ai ...
Intake Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad. (Refer to BD group - "Crash Pad") ...
See also:

AGM Battery: Description
AGM battery is used for especially heavy load on the vehicle network depending on equipment and requirements. AGM stands for Absorbent Glass Material Battery; that is absorbent glass fibre fl ...

Installation
1. Installation is the reverse of removal. 2. After installation, bleed the brake system. (Refer to Brake system bleeding) ...

Auto Light Sensor Installation
1. Reconnect the auto light connector. 2. Install the auto light sensor. ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts