Kia Rio: Passenger Airbag (PAB) ModuleInstallation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable from battery and wait for at least thirty seconds before beginning work.

Place the passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

4.	Install the heater duct to the crash pad.

5.	Install the crash pad. (Refer to the Body group- "Crash pad")

Tighten the passenger airbag crash pad mounting bolt.

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

7.	Connect the passenger airbag harness connector to the SRS main harness connector.

8.	Reinstall the glove box. (Refer to the Body group - "Crash pad")

9.	Reconnect the battery negative cable.

10.

After installing the passenger airbag (PAB), confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Passenger Airbag (PAB) Module Removal

1. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 2. Remove the glove box housing. ...

Side Airbag (SAB) Module Description

The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag by using Si ...

Kia Rio: Passenger Airbag (PAB) ModuleInstallation

Passenger Airbag (PAB) Module Removal

Side Airbag (SAB) Module Description

See also: