Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Power Mosfet (FATC) Inspection - Blower - Heating,Ventilation, Air Conditioning - Kia Rio UB 2012-2020 Service ManualKia Rio: Power Mosfet (FATC) Inspection

1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of blower motor.
3.
Select the control switch to raise voltage until high speed.


Specification
Fan Speed
(Manual)
Motor Voltage (V)
1
3.75 0.5
2
4.76 0.5
3
6.87 0.5
4
6.99 0.5
5
8.11 0.5
6
9.23 0.5
7
10.63 0.5
8
Battery

4.
If the measured voltage is not within specification, substitute with a known-good power mosfet and check for proper operation.
5.
Replace the power mosfet if it is proved that there is a problem with it.
Blower Resistor (MANUAL) Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (A) and then remove the blower resistor (B) after loosening th ...
Power Mosfet (FATC) Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (A) and then remove the power mosfet (B) after loosening the m ...
See also:

Hands free switch Inspection
1. Check the hands free remote control switch for resistance between No.4 and No.5 terminals in each switch position. Audio + Bluetooth [LH] ...

Rear Wheel Alignment
   When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always p ...

Spark Plug: Installation
1. Install in the reverse order of removal. Spark Plug Installation : 14.7 ~ 24.5 N.m (1.5 ~ 2.5 kgf.m, 10.8 ~ 18.0 Ib-ft) ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts