Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Rear Wheel Alignment - Tires/Wheels - Suspension System - Kia Rio UB 2012-2020 Service ManualKia Rio: Rear Wheel Alignment


     
When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always position the vehicle on a level surface.
Prior to inspection, make sure that the rear suspension system is in normal operating condition and that the tires are inflated to the specified pressure.
Toe



B - A > 0: Toe in (+)
B - A < 0: Toe out (-)

Toe is pre-set at the factory, so it does not need to be adjusted. If the toe is not within the standard value, replace or repair the damaged parts and then inspect again.

Toe:
Total : 0.5 (+0.4/ -0.5)
Individual :0.25(+0.2/ -0.25)

Camber
Camber is pre-set at the factory, so it does not need to be adjusted. If the camber is not within the standard value, replace or repair the damaged parts and then inspect again.

Camber : -1.50.5

Front Wheel Alignment
   When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always ...
Wheel Hub Nut Tightening Sequence
Tighten the hub nuts as follows. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)    ...
See also:

26 Brake Control Solenoid Valve(26/B_VFS) Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Front Wheel Speed Sensor Components
1. Front wheel speed sensor connector 2. Front wheel speed sensor ...

Immobilizer Control Unit Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") ...

Copyright © www.kiamanual.com 2020-2021