Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Rear Wheel Speed Sensor Removal - ESC(Electronic Stability Control) System - Brake System - Kia Rio UB 2012-2020 Service ManualKia Rio: Rear Wheel Speed Sensor Removal

1.
Remove the rear wheel and tire.

Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.
Remove the rear wheel speed sensor mounting bolt (A).

Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)


3.
Remove the rear seat back.
(Refer to the Body group - "Seat")
4.
Remove the rear wheel housing trim.
(Refer to the Body group "Interior trim")
5.
Disconnect the rear wheel speed sensor connector.
6.
Installation is the reverse of removal.
Rear Wheel Speed Sensor Components
1. Rear wheel speed sensor connector 2. Rear wheel speed sensor ...
Rear Wheel Speed Sensor Inspection
1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground.    ...
See also:

Washer fluid
Checking the washer fluid level Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use washer sol ...

Removal
1. Disconnect the battery negative (-) cable. 2. Disconnect the battery sensor connector. 3. Remove the battery ...

In car sensor (FATC only) Description
The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the r ...

Copyright © www.kiamanual.com 2020-2021