Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Rear Wiper Motor Inspection - Rear Wiper/Washer - Body Electrical System - Kia Rio UB 2012-2020 Service ManualKia Rio: Rear Wiper Motor Inspection

Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 4 and 1 respectively.
3.
Check that the motor operates normally. Replace the motor if it operates abnormally.


Pin No.
Description
1
Battery +
2
-
3
Switch
4
Ground

Automatic Stop Operation Check
1.
Operate the motor at low speed using the stalk control.
2.
Stop the motor operation anywhere except at the off position by disconnecting terminal 3.
3.
Connect terminals 2 and 3.
4.
Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 4.
5.
Check that the motor stops running at the off position.


Rear Wiper Motor Installation
1. Install the rubber packing. 2. Install the rear wiper motor assembly. Tightening torque : 6.86 ~ 9.81N ...
Rear Washer Switch Inspection
1. With the rear wiper & washer switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace t ...
See also:

Installation
   Install the component with the specified torques. ...

Climate Control Air Filtar Replacement
1. Open the glove box. 2. Remove the filter cover (A) by pressing the knob. 3. Replace the air filter ( ...

Foot Actuator (With Auto Defogging System) Description
The foot actuator is located at the heater unit. It adjusts position of the foot door in heater unit of the vehicle equipped with the auto defogging system. ...

Copyright © www.kiamanual.com 2020-2021