Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Removal - Multifunction switch - Body Electrical System - Kia Rio UB 2012-2020 Service ManualKia Rio: Removal

Wiper and Washer Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
3.
Remove the steering column upper (A) and lower (B) shrouds after removing the screw.



4.
Disconnect the connector(A). Release the lock of wiper switch using tool without removing the steering wheel and the clock spring.
Remove the wiper and washer switch.


Multifunction Switch Assembly
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
3.
Remove the steering column upper and lower shrouds after removing 3 screws.
4.
Remove the clock spring.
(Refer to the RT group - "Airbag module")
5.
Disconnect the lighting switch connector and wiper & washer switch connector.
Remove the multifunction switch assembly (A) after loosening 2 mounting screws.


Inspection
Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...
Installation
Multifunction Switch 1. Install the multifunction switch. 2. Install the clock spring. 3. Install the steer ...
See also:

Seat Heater Switch Installation
1. Install the seat heater switch. 2. Install the console assembly. 3. Connect the battery (-) terminal. ...

Rain Sensor Removal
   The rain sensor may not operate properly if contaminated. Protect the rain sensor surface by not removing the cover unti ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Direct control VFS[T/CON] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81 ~ 500.14 (0.1 ~ 5.1,1.42 ~ 72.54) Current value(mA ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts