Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Removal - Brake Line - Brake System - Kia Rio UB 2012-2020 Service ManualKia Rio: Removal

1.
Disconnect the brake fluid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservoir with a syringe.

     
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
3.
Remove the wheel & tire.
4.
Loosening the tube flare nut (B).

Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

[Front]


[Rear]


5.
Disconnect the brake tube by remove the brake hose clip (A).
6.
Disconnect the brake hose from the brake caliper by loosening the bolt (A).

Tightening torque:
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)

[Front disc brake]


[Rear Disc brake]


Components
...
Inspection
1. Check the brake tubes for cracks, crimps and corrosion. 2. Check the brake hoses for cracks, damage and fluid leakage. 3 ...
See also:

Schematic Diagram
...

Components
1. Shoe hold down pin 2. Shoe adjuster 3. Upper return spring 4. Adjusting lever 5. Shoe 6. Adjusting spring 7. Lower return spring 8. Shoe hold spring ...

Rear Coil Spring Inspection
1. Check the coil spring for crack and deformation. 2. Check the coil spring pad for damage and deformation. ...