Kia Rio: Removal

•	DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.

[Bank 1 / Intake]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the camshaft position sensor connector (A).

3.	Remove the installation bolt (B), and then remove the sensor.

[Bank 1 / Exhaust]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the camshaft position sensor connector (A).

3.	Remove the hanger and the protector.

4.	Remove the installation bolt (B), and then remove the sensor.

1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” ...

• Install the component with the specified torques. • ...