Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Spark Plug: Inspection - Ignition System - Engine Electrical System - Kia Rio UB 2012-2020 Service ManualKia Rio: Spark Plug: Inspection

[On vehicle inspection]
1.
Accelerate the engine to about 3,000 rpm 3 times or more.
2.
Remove the spark plug.
3.
Check the spark plug visually.
If the electrode is dry, the spark plug is normal.
If the electrode is wet, check the damage and electrode gap as below.
[Component Inspection]
1.
Check the spark plug for any damage on its thread and insulator.
If there is damage, replace the spark plug.
2.
Check the electrode. Measure the insulation resistance with an ohmmeter.
If the resistance is less than the specified value, adjust the electrode gap.

Specification: 10 MΩ or more


3.
Check the spark plug electrode gap.
If the gap is greater than the maximum, replace the spark plug.

Specification: 0.9 ~ 1.0 mm (0.0354 ~ 0.0394 in.)


     
If adjusting the gap of a new spark plug, bend only the base of the ground electrode. Do not touch the tip.
Never attempt to adjust the gap on a used plug.


Spark Plug: Specification
Item Specification Type SILZKR6B10E Gap 0.9 ~ 1.0 mm (0.0354 ~ 0.0394 in.) ...
Spark Plug: Cleaning
The combustion temporarily becomes unstable, due to the aged fuel and the carbon deposits accumulated on the spark plug(s) after long-term storage. [1st Method] 1. ...
See also:

Hands free switch Inspection
1. Check the hands free remote control switch for resistance between No.4 and No.5 terminals in each switch position. Audio + Bluetooth [LH] ...

Description
Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine ...

Auto Light Switch Inspection
Operate the auto light switch, then check for continuity between terminals of multi-function switch connector. ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts