< html xmlns="http://www.w3.org/1999/xhtml" dir="ltr" lang="en-US"> Kia Rio: TJ Joint Inspection - Driveshaft Assembly - Driveshaft and axle - Kia Rio UB 2012-2020 Service Manual
Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: TJ Joint Inspection - Driveshaft Assembly - Driveshaft and axle - Kia Rio UB 2012-2020 Service ManualKia Rio: TJ Joint Inspection

1.
Check the spider assembly for roller rotation, wear or corrosion.
2.
Check the groove inside the joint case for wear or corrosion
3.
Check the TJ boots for damage and deterioration.
TJ Joint Replacement
   Special grease must be applied to the driveshaft joint. Do not substitute with another ...
TJ Joint Installation
1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...
See also:

Mode Control Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad. (Refer to BD group - "Crash Pad") ...

Description
Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor that changes re ...

Description
Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of the air tem ...

Copyright © www.kiamanual.com 2020-2021