Kia Rio: TJ Joint Installation

1.	Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot.

2.	Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and snap ring (B) on the driveshaft splines (C).

3.	Add specified grease to the joint boot as much as it was wiped away at inspection.

4.	Install the both boot band.

To control the air in the TJ boot, keep the specified distance between the boot bands when they are tightened.

Engine& T/M	Distance(L) mm(in)
Engine& T/M	LH side	RH side
Gasoline 1.6 & M/T	512.5(20.2)	792.9(31.2)
Gasoline 1.6 & A/T	489.6(19.3)	781.3(30.8)

Using the SST(09495-3K000), secure the TJ boot bands.

Clearance (A): 2.0 mm (0.079 in) or less

7.	Install the Front Driveshaft. (Refer to DS group - “Front Driveshaft”)

TJ Joint Inspection

1. Check the spider assembly for roller rotation, wear or corrosion. 2. Check the groove inside the joint case for wear or corrosion ...

Dynamic Damper Components

1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

Kia Rio: TJ Joint Installation

TJ Joint Inspection

Dynamic Damper Components

See also: