Kia Cee'd: Engine Control System / Accelerator Position Sensor (APS) Description and operation
Kia Cee'd JD Service Manual / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Description and operation
Description |
Accelerator Position Sensor (APS) is installed on the accelerator pedal module
and detects the rotation angle of the accelerator pedal. The APS is one of the
most important sensors in engine control system, so it consists of the two sensors
which adapt individual sensor power and ground line. The second sensor monitors
the first sensor and its output voltage is half of the first one. If the ratio
of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic
system judges that it is abnormal.
Rail Pressure Sensor (RPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine spee ...Accelerator Position Sensor (APS) Specifications
Specification Accelerator Position Output Voltage (V) [Vref=5V] APS1 APS2 C.T 0.7 ~ 0.8 ...Other information:
Kia Cee'd JD Service Manual: Exhaust Manifold Components and components location
Components
1. Heat protector
2. Exhaust manifold
3. Gasket
4. Exhaust manifold stay
...
Kia Cee'd JD Service Manual: Rear Upper Arm Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 1 ...