Kia Cee'd: Auto Lighting Control System / Auto Light Sensor Repair procedures
Kia Cee'd JD Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor Repair procedures
| Inspection |
In the state of IGN1 ON, when multifunction switch module detects auto light
switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto light sensor's input.
The auto light control doesn't work if the pin sunlight supply (5V regulated
power from Ignition 1 power to sunlight sensor) is in short circuit with the
ground.
If IGN1 ON, The BCM monitors the range of this supply and raises up a failure
as soon as the supply’s voltage is out of range. Then this failure occurs and
as long as this is present, the head lamp must be turned on without taking care
about the sunlight level provided by the sensor.
This is designed to prevent any head lamp cut off when the failure occurs during
the night.
| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the auto light sensor (A) from crash pad upper side by using
screw (-) driver.
|
| 3. |
Remove the auto light connector (B).
|
| Installation |
| 1. |
Reconnect the auto light connector.
|
| 2. |
Install the auto light sensor.
|
Schematic diagrams
Circuit Diagram
...
Other information:
Kia Cee'd JD Service Manual: Rear Cross Member Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 1 ...
Kia Cee'd JD Owners Manual: Remote control
The electric remote control mirror switch
allows you to adjust the position of the
left and right outside rearview mirrors. To
adjust the position of either mirror, move
the lever (1) to R (Right) or L (Left) to
select the right side mirror or the left side
mirror, then press a corresp ...