Kia Cee'd: Automatic climate control system / Checking the amount of air conditioner refrigerant and compressor lubricant
When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a bad influence on the air conditioning system.
Therefore, if abnormal operation is found, we recommend that the system be inspected by an authorized Kia dealer.
WARNING - Vehicles equipped with R-134a*
Because the refrigerant is at very high pressure, the air conditioning system should only be serviced by trained and certified technicians. It is important that the correct type and amount of oil and refrigerant is used. Otherwise, it may cause damage to the vehicle and personal injury.
WARNING - Vehicles equipped with R-1234yf*
Because the refrigerant is mildly inflammable and at very high pressure, the air conditioning system should only be serviced by trained and certified technicians. It is important that the correct type and amount of oil and refrigerant is used.
Otherwise, it may cause damage to the vehicle and personal injury.
Climate control air filter
The climate control air filter installed
behind the glove box filters the dust or
other pollutants that come into the vehicle
from the outside through the heating
and air conditioning system ...
Windshield defrosting and defogging
WARNING - Windshield
heating
Do not use the position
during
cooling operation in extremely
humid weather. The difference
between the temperature of the outside
air and the windshield cou ...
Other information:
Kia Cee'd JD Service Manual: Rail Pressure Sensor (RPS) Description and operation
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the
instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor
element) built in the sensor converts the pressure to voltage signal. By using
this signal, the ECM ...
Kia Cee'd JD Service Manual: Fuel Pump Repair procedures
Inspection
[Fuel pump]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
3.
Check motor operation by fuel pump connector (A) connecting power (No. ...