Kia Cee'd: Restraint / Description and operation
Kia Cee'd JD Service Manual / Restraint / Description and operation
| Warning Lamp Activation |
| Warning Lamp Behavior after Ignition On |
As soon as the operating voltage is applied to the SRSCM ignition input, the
SRSCM activates the warning lamp for a LED lamp check.
The lamp shall turn on for 6 seconds during the initialization phase and be
turned off afterward.
To alert the driver, the warning lamp shall turn on for 6 seconds and off for
one second then on continuously after the operating voltage is applied if any
active fault exists.
| 1. |
Active fault or historical fault counter is greater or equal to 10.
|
| 2. |
Normal or historical fault counter is less than 10.
|
| 3. |
When turning the ignition switch ON during variant coding (EOL) mode,
the airbag warning lamp is turned on and blinks at intervals of 1 second
till the coding is completed.
In case the variant coding is normally completed, the airbag warning
lamp is turned on for 6 seconds, and then turned off. Otherwise the
airbag warning lamp continuously blinks at intervals of 1 second.
When there is active fault in airbag system or SRSCM internal fault,
the variant coding (EOL) can’t be completed. In this case, do the variant
coding (EOL) procedure again after troubleshooting with the GDS.
|
SRSCM Independent Warning Lamp Activation
There are certain fault conditions in which the SRSCM cannot function and thus
cannot control the operation of the standard warning lamp. In these cases, the
standard warning lamp is directly activated by appropriate circuitry that operates
independently of the SRSCM. These cases are:
| 1. |
Loss of battery supply to the SRSCM : warning lamp turned on continuously.
|
| 2. |
Loss of internal operating voltage : warning lamp turned on continuously.
|
| 3. |
Loss of Microprocessor operation : warning lamp turned on continuously.
|
| 4. |
SRSCM not connected : warning lamp turned on continuously.
|
General safety information and caution
Precautions
General Precautions
Please read the following precautions carefully before performing the airbag
system service.
Observe the instructions described in ...
Repair procedures
Component Replacement After
Deployment
Before doing any SRS repairs, use the GDS to check for DTCs. Refer to ...
Other information:
Kia Cee'd JD Owners Manual: Closing the hood
1. Before closing the hood, check the following:
All filler caps in engine compartment
must be correctly installed.
Gloves, rags or any other combustible
material must be removed
from the engine compartment.
2. Return the support rod to its clip to
prevent it from rattling.
3. L ...
Kia Cee'd JD Service Manual: Gear Actuator Repair procedures
Removal
1.
Turn off the ignition switch and then disconnect the battery (-) cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
3.
...