Kia Cee'd: Brake System / Master Cylinder Repair procedures

Kia Cee'd JD Service Manual / Brake System / Brake System / Master Cylinder Repair procedures

Removal [LHD]

1.	Turm ignition switch OFF and disconnect the negative (-) battery cable.

2.	Remove the battery. (Refer to Engine Electrical system-"Battery")

3.	Remove the ECM. (Refer to Engine control / Fuel System -"Engine Control Module")

4.	Disconnect the brake fluid level switch connector (A), and remove the reservoir cap.

Remove the brake fluid from the master cylinder reservoir with a syringe.

•	Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.

Disconnect the brake tube (A) from the master cylinder by loosening the tube flare nut.

Tightening torque:

ABS : 12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

ESP : 18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

7.	Remove the clutch hose (B). [MT only]

Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (A).

Tightening torque:

9.8 ~ 15.7 N.m (1.0 ~ 1.6 kgf.m, 7.2 ~ 11.2 lb-ft)

Removal [RHD]

1.	Turm ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect the brake fluid level switch connector (A), and remove the reservoir cap.

Remove the brake fluid from the master cylinder reservoir with a syringe.

•	Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.

Disconnect the brake tube (A) from the master cylinder by loosening the tube flare nut.

Tightening torque:

ABS : 12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

ESP : 18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

5.	Remove the clutch hose (B). [MT only]

Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (A).

Tightening torque:

9.8 ~ 15.7 N.m (1.0 ~ 1.6 kgf.m, 7.2 ~ 11.2 lb-ft)

Installation

1.	Install in the reverse order of removal.

2.	After installation, bleed the brake system. (Refer to Brake system bleeding)

Master Cylinder Components and components location

Components [LHD] 1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder Components [RHD] 1. Reserv ...

Brake Line Components and components location

Components ...

Other information:

Kia Cee'd JD Service Manual: Accelerator Position Sensor (APS) Description and operation
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual ...

Kia Cee'd JD Service Manual: ETC (Electronic Throttle Control) System Troubleshooting
Fail-Safe Mode Item Fail-Safe ETC Motor Throttle valve stuck at 7° TPS TPS 1 fault ECM looks at TPS2 TPS 2 fault ECM looks at TPS1 TP ...