Kia Cee'd: SRSCM / PAB ON/OFF Switch Repair procedures

Kia Cee'd JD Service Manual / Restraint / SRSCM / PAB ON/OFF Switch Repair procedures

Removal

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

3.	Remove the crash pad side cover. (Refer to Body - "Crash pad side cover")

4.	Disconnect the PAB ON/OFF switch connector (A).

5.	Remove the PAB ON/OFF switch.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

3.	Install the PAB ON/OFF switch to the crash pad side cover.

4.	Connect the PAB ON/OFF switch connector.

5.	Install the crash pad side cover. (Refer to Body - "Crash pad side cover")

After installing the SRSCM, confirm proper system operation:

•	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

PAB ON/OFF Switch Components and components location

Components ...

Airbag Module

...

Other information:

Kia Cee'd JD Service Manual: Rear Door Latch Repair procedures
Replacement 1. Remove the rear door module. (Refer to Rear Door - "Rear Door Module") 2. Remove the rear door outside handle base (A) by pushing in the lock pins located in the back. 3. ...

Kia Cee'd JD Owners Manual: AUTO (Automatic) control
The rain sensor located on the upper end of the windshield glass senses the amount of rainfall and controls the wiping cycle for the proper interval. The more it rains, the faster the wiper operates.When the rain stops, the wiper stops. To vary the speed setting, turn the speed contro ...