Kia Cee'd: Ignition Lock Switch / Repair procedures

Kia Cee'd JD Service Manual / Clutch System / Ignition Lock Switch / Repair procedures

Inspection

Signal Circuit Inspection

Check ignition lock switch pull-up voltage

(1)	IG KEY "OFF", ENGINE "OFF".

(2)	Disconnect ignition lock switch connector.

(3)	IG KEY "ON".

(4)

Measure the voltage between signal terminal of ignition lock switch harness connector and chassis ground.

Specification : 11.5V ~ 13.0V

Check open in ignition lock switch signal circuit

(1)	IG KEY "OFF", ENGINE "OFF".

(2)	Disconnect ignition lock switch connector and ECM connector.

(3)

Check continuity between signal terminal of lock switch signal harness connector and ECM harness connector.

Specification : Continuity ( below 1.0Ω )

Ground Circuit inspection

1.	IG KEY "OFF", ENGINE "OFF".

2.	Disconnect ignition lock switch connector.

Check continuity between lock switch signal connector terminal 1 and chassis ground.

Specification : Continuity ( below 1.0Ω )

Component Inspection

1.	Remove the ignition lock switch.

Push the ignition lock switch in the direction of the arrow to make sure that continuity between terminals. (refer to the table below)

Standard value :

Full stroke (A): 12.0 ± 0.3mm (0.4724 ± 0.0118 in.)

ON-OFF point (B): 2.0 mm(0.0787 in.)

Condition	Clutch Pedal pressed	Clutch Pedal Released
Switch Operation	ON (below 1.0Ω )	OFF ( Infinite Ω )

Removal

1.	Turn ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect ignition lock switch connector (A).

3.	Remove the ignition lock switch by loosening a nut (A).

Installation

1.	Install in the reverse order of removal.

Adjust the ignition switch.

(1)

In state of full stroke, adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.

Standard gap range :

Gasoline : 3 ~ 4 mm (0.1181 ~ 0.1575 in.)

Diesel : 1 ~ 2 mm (0.0394 ~ 0.0787 in.)

(2)

Tighten the nut (B) with the specified torque.

Tightening torque:

7.8 ~ 9.8 N (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Specifications

Specifications Item Specifications Working voltage DC 12V Operating force 14.7 ± ...

Clutch Pedal Components and components location

Components 1. Master cylinder 2. Ignition lock switch 3. Clutch switch 4. Pedal pad ...

Other information:

Kia Cee'd JD Service Manual: Specifications
Specification Engine T/M Joint type Max . permissible angle Outer Inner Outer Inner Gamma 1.4 MPI 6 M/T BJ#22 TJi#22 ...

Kia Cee'd JD Service Manual: Front Seat Frame Assembly Components and components location
Component Location 1. Front seat back frame assembly 2. Front seat cushion frame assembly ...