Kia Cee'd: Clutch Master Cylinder / Repair procedures

Kia Cee'd JD Service Manual / Clutch System / Clutch Master Cylinder / Repair procedures

Removal

1.	Separate the push rod (C) after remove the pin (A) and washer (B).

Remove the battery and battery tray.

G 1.6 MPI (Refer to Engine Electrical System - "Battery")

G 1.4 MPI (Refer to Engine Electrical System - "Battery")

D 1.6 TCI-U2 (Refer to Engine Electrical System - "Battery")

D 1.4 TCI-U2 (Refer to Engine Electrical System - "Battery")

G 1.6 GDI (Refer to Engine Electrical System - "Battery")

G 1.6 T-GDI (Refer to Engine Electrical System - "Battery")

Remove the ECM.

G 1.6 MPI (Refer to Engine Control / Fuel System - "Engine Control Module")

G 1.4 MPI (Refer to Engine Control / Fuel System - "Engine Control Module")

D 1.6 TCI-U2 (Refer to Engine Control / Fuel System - "Engine Control Module")

D 1.4 TCI-U2 (Refer to Engine Control / Fuel System - "Engine Control Module")

G 1.6 GDI (Refer to Engine Control / Fuel System - "Engine Control Module")

G 1.6 T-GDI (Refer to Engine Control / Fuel System - "Engine Control Module")

4.	The case of diesel vehicle, remove the fuel filter. D 1.6 TCI-U2 (Refer to Engine Control / Fuel System - "Fuel Filter") D 1.4 TCI-U2 (Refer to Engine Control / Fuel System - "Fuel Filter")

Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.

•	Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

[Gasoline]

[Diesel]

6.	Remove the master cylinder (A) by rotating in a clockwise direction.

Installation

1.	Install in the reverse order of removal.

2.	After be equipped, perform bleeding air procedure in clutch release cylinder after pouring the brake fluid. (Refer to Clutch System - "Clutch release cylinder")

Components and components location

Components 1. Master cylinder 2. Ignition lock switch 3. Clutch switch 4. Pedal pad ...

Clutch Release Cylinder

...

Other information:

Kia Cee'd JD Service Manual: Head Lamps Repair procedures
Inspection 1. Check-points upon head lamp failure (HID) (1) Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) (2) Check the fuse and relay. ...

Kia Cee'd JD Service Manual: Description and operation
Description • Ignition lock switch is mounted on the clutch pedal. • Ignition lock switch is operated when you press the clutch pedal. ...