Kia Cee'd: Blind Spot Detection system / Repair procedures
Kia Cee'd JD Service Manual / Body Electrical System / Blind Spot Detection system / Repair procedures
| Diagnosis With GDS |
| 1. |
BSD system defects can be quickly diagnosed with the GDS. GDS operates
actuator quickly to monitor, input/output value and self diagnosis.
|
| 2. |
Connect the cable of GDS to the data link connector in driver side crash
pad lower panel, turn the power on GDS.
|
| 3. |
Select the vehicle model and then BSD system.
|
| 4. |
Select "Input/output monitoring", if you want to check current data
of BSD system.
|
| 5. |
If you want to check each module operation forcefully, select "Actuation
test".
|
| 6. |
Ignition "OFF", connect GDS.
|
| 7. |
Ignition "ON” & Engine "OFF", select BSD system and "BSD Radar Calibration"
mode.
|
| 8. |
The GDS will show the BSD Reset function steps.
|
| 9. |
The BSD initialization procedure will be performed.
|
Description and operation
Description
BSD is a system that uses two magnetic wave radar sensors attached on the rear
panel to measure the distance from the following vehicles and provides the sensing
...
Blind Spot Detection Unit" Schematic diagrams
Circuit Diagram
...
Other information:
Kia Cee'd JD Service Manual: Repair procedures
Dual Clutch Transmission(DCT)
Learning
1.
Learning overview and purpose
–
Checks gear shift precision and normal clutch operation in the
finished car to ensure accurate Dual Clutch Transmission (DCT)
control by th ...
Kia Cee'd JD Owners Manual: 3. Search for parking space (optional)
Slowly drive forward maintaining the
distance of approximately 50cm ~
150cm (19.6in.~59.0in.) with the
parked vehicles. The side sensors will
search for a parking space.
If the vehicle speed is over 20km/h
(12.4mph), a message will appear to
notify to reduce speed.
If the ...