Kia Cee'd: Evaporative Emission Control System / Repair procedures

Kia Cee'd JD Service Manual / Emission Control System / Evaporative Emission Control System / Repair procedures

Inspection

[System Inspection]

1.	Disconnect the vapor hose from the throttle body and connect a vacuum pump to the nipple on the throttle body.

Check the following points with applied vacuum using a vacuum pump.

· At Cold Engine [Engine Coolant Temperature < 60°C(140°F)]

Engine Operating Condition	Applied Vacuum	Result
Idle	0.5kgf/cm² (50kPa,7.3psi)	Vacuum is held
3,000rpm	0.5kgf/cm² (50kPa,7.3psi)	Vacuum is held

· At Warmed Engine [Engine Coolant Temperature > 80°C(176°F)]

Engine Operating Condition	Applied Vacuum	Result
Idle	0.5kgf/cm² (50kPa,7.3psi)	Vacuum is held
Within 3 minutes after engine start at 3,000 rpm	Try to apply vacuum	Vacuum is released
In 3 minutes after engine start at 3,000 rpm	0.5kgf/cm² (50kPa,7.3psi)	Vacuum will be held momentarily, after which, it will be released

[PCSV Inspection]

1.	Turn ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect the PCSV connector (A).

3.	Disconnect the vapor hose (B) which is connected to the intake manifold from the PCSV.

4.	After connecting a vacuum pump to the nipple, apply vacuum.

With the PCSV control line grounded, check the valve operation with battery voltage applied to the PCSV(Open) and removed(Closed).

Battery Voltage	Valve	Vacuum
Connected	Open	Released
Disconnected	Close	Maintained

Measure the coil resistance of the PCSV.

Specifications : 22.0 ~ 26.0Ω [20°C(68°F)]

Schematic diagrams

Schematic Diagram Canister Canister is filled with charcoal and absorbs evaporated vapor in fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold ...

Canister Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the fuel tank assembly. (Ref ...

Other information:

Kia Cee'd JD Owners Manual: To defog inside windshield
1. Set the fan speed to the desired position. 2. Select desired temperature. 3. Select the position. 4. The outside (fresh) air will be selected automatically. If the position is selected, air conditioning (if equipped) will also be selected automatically. If the air conditioning and/o ...

Kia Cee'd JD Service Manual: Power Outside Mirror Switch Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the the crash pad garnish [LH] (A). (Refer to Body - "Cluster Fascia Panel") 3. Check for continuity ...