Kia Rio: Tires/Wheels / Alignment
Repair procedures
| Front wheel alignment |
When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheels facing straight ahead. Prior to inspection, make sure that the front suspension and steering system are in normal operating condition and that the tires are inflated to the specified pressure. |
Toe
|
B - A > 0: Toe in (+) B - A < 0: Toe out (-) |
Toe adjustment
| 1. |
Loosen the tie rod end lock nut. |
| 2. |
Remove the bellows clip to prevent the bellows from being twisted. |
| 3. |
Adjust the toe by screwing or unscrewing the tie rod. Toe adjustment should be made by turning the right and left tie rods by the same amount.
|
| 4. |
When completing the toe adjustment, install the bellows clip and tighten the tie rod end lock nut to specified torque.
|
| 5. |
Perform the Steering Angle Sensor calibration.
|
Camber and Caster
Camber and Caster are pre-set at the factory, so they do not need to be adjusted. If the camber and caster are not within the standard value, replace or repair the damaged parts and then inspect again.
|
Camber angle : (EU/AUS) -0.5°±0.5° (GEN) -0.4°±0.5° |
|
Caster angle : (EU/AUS) 4.65°±0.5° (GEN) 4.54°±0.5° |
Wheel
Repair procedures
Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque:
107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)
...
Tire Pressure Monitoring System
Components and components location
Components
1. HECU
2. Cluster
3. TPMS SET Switch
4. Wheel speed sensor
5. Tone wheel
Description and oper ...
Other information:
Kia Rio 2017-2020 YB Service Manual: Power Window Motor
Components and components location Components [Standard window motor] [Safety window motor] Repair procedures Inspection • When removing with a ...
Kia Rio 2017-2020 YB Owners Manual: Trunk/Liftgate room lamp
• 4 Door • 5 Door The trunk/liftgate room lamp comes on when the trunk/liftgate is opened. The trunk/liftgate room lamp comes on as long as the trunk/liftgate lid is open. To prevent unnecessary charging system drain, close the trunk/liftgate lid securely after using the trunk/liftgat ...