Kia Rio: ESC (Electronic Stability Control) System / ESC Control Module

Kia Rio 2017-2020 YB Service Manual / Brake System / ESC (Electronic Stability Control) System / ESC Control Module

Components and components location

Components

1. ESC control module connector
2. ESC control module

3. ESC bracket

Repair procedures

Removal

1.	Turn ignition OFF and disconnect the negative (-) battery cable.

Remove the brake fluid from the master cylinder reservoir with a syringe.

•	Be sure to completely remove foreign substances from around brake fluid reservoir and cap before opening the reservoir cap. Otherwise, it may cause contamination of brake fluid and deterioration in braking performance.

•	Do not spill brake fluid on the vehicle as it may damage the paint. If brake fluid comes in contact with the paint, wash off immediately with water.

3.	Pull up the lock of the ESC connector (A) and then disconnect the connector.

Disconnect the brake tubes from the ECS by unlocking the nuts counterclockwise with a wrench.

Tightening torque:

A : 13.7 - 16.7 N·m (1.4 - 1.7 kgf·m, 10.1 - 12.3 lb·ft)

B : 18.6 - 22.6 N·m (1.9 - 2.3 kgf·m, 13.7 - 16.6 lb·ft)

Loosen the ESC control module bracket nuts (A), and then remove the ESC control module bracket.

Tightening torque:

16.7 - 25.5 N·m (1.7 - 2.6 kgf·m, 12.3 - 18.8 lb·ft)

•	Never attempt to disassemble the ESC.

•	The ESC must be transported and stored in.

•	Never shock to the ESC.

Installation

1.	Install in the reverse order of removal.

2.	After installation, bleed the brake system. (Refer to Brake system - "Brake System")

3.	Conduct the Variant coding.

4.	Conduct the Auto Detected Sensor Calibration.

5.	Conduct the Longitudinal G Sensor Calibration.

Diagnostic procedure by using diagnostic device

Perform diagnostic procedure by using diagnostic device as shown below:

Connect self-diagnosis connector (16pins) located under the driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON.

Select the "vehicle model" and "ABS/ESC" on GDS vehicle selection screen, then select OK.

[Variant Coding]

[Auto Detected Sensor Calibration]

[Longitudinal G Sensor Calibration]

ESC (Electronic Stability Control) System

Components and components location Components 1. ESC control module 2. Front wheel speed sensor 3. Rear wheel speed sensor Description and operat ...

Front Wheel Speed Sensor

Components and components location Components 1. Front wheel speed sensor connector 2. Front wheel speed sensor Repair procedures Removal ...

Other information:

Kia Rio 2017-2020 YB Service Manual: Trunk Lid Assembly

Components and components location Component Location (4Door) 1. Trunk lid assembly Repair procedures Replacement (4Door) • ...

Kia Rio 2017-2020 YB Service Manual: Antenna Coil

Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the steering column upper and lower shroud pan ...