Kia Rio: Electronic stability control (ESC) / ESC operation
Kia Rio 2017-2020 YB Owners Manual / Driving your vehicle / Brake system / Electronic stability control (ESC) / ESC operation
ESC ON condition
- When the ignition is turned ON, ESC and ESC OFF indicator lights illuminate for approximately 3 seconds, then ESC is turned on.
- Press the ESC OFF button for at least half a second after turning the ignition ON to turn ESC off. (ESC OFF indicator will illuminate). To turn the ESC on, press the ESC OFF button (ESC OFF indicator light will go off).
- When starting the engine, you may hear a slight ticking sound. This is the ESC performing an automatic system self-check and does not indicate a problem.
When operating
When the ESC is in operation, ESC indicator light blinks.
- When the Electronic Stability Control is operating properly, you can feel a slight pulsation in the vehicle. This is only the effect of brake control and indicates nothing unusual.
- When moving out of the mud or slippery road, pressing the accelerator pedal may not cause the engine rpm (revolutions per minute) to increase.
Electronic stability control (ESC)
The Electronic Stability control (ESC) system is designed to stabilize the vehicle during cornering maneuvers. ESC checks where you are steering and where the vehicle is actually going. ESC appl ...ESC operation off
ESC OFF state This car has 2 kinds of ESC off states. If the engine stops when ESC is off, ESC remains off. Upon restarting the engine, the ESC will automatically turn on again. • ESC off s ...Other information:
Kia Rio 2017-2020 YB Owners Manual: Rear view monitor system
Rear View Monitor function ■ Type A ■ Type B Rear View Monitor system will activate with the ignition switch on and the shift lever in the R (Reverse) position. Please note that during initial start up, the rear view monitor may not display instantly due to the audio system booting ...
Kia Rio 2017-2020 YB Service Manual: Rheostat
Components and components location Components Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") ...