Kia Rio: Lubrication System / Oil Pressure Switch
Repair procedures
| Removal and Installation |
| 1. |
Disconnect the oil pressure switch connector (A) and then remove the oil pressure switch (B).
|
| 2. |
Install in the reverse order of removal.
|
| Inspection |
| 1. |
Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch.
|
| 2. |
Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch. |
| 3. |
If there is no continuity when a 50 kPa (0.50 kgf/cm², 7.25 psi) is applied through the oil hole, the switch is operaing properly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.
|
Engine Oil
Flow diagram
Flow Diagram
Repair procedures
Engine Oil And Filter Replacement
•
...
Oil Pan
Components and components location
Components
1. Oil screen O-ring
2. Oil screen
3. Oil pan
4. Drain plug gasket
5. Drain plug
Repair proced ...
Other information:
Kia Rio 2017-2020 YB Service Manual: Room Lamp
Repair procedures Removal • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective t ...
Kia Rio 2017-2020 YB Service Manual: Cruise Control Switch
Components and components location Components 1. Left Remote Control Switch (Audio + Hands free + Voice) 2. Right Remote Control Switch (Cruise+Trip Computer) Schematic diagrams Circuit Diagram [Audio] ...