Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Seat belt restraint system / Seat belt warning

Kia Rio 2017-2020 YB Owners Manual / Safety features of your vehicle / Seat belts / Seat belt restraint system / Seat belt warning

As a reminder to the driver, the driver’s seat belt warning lights will illuminate and warning chime will sound for approximately 6 seconds each time you turn the ignition switch ON regardless of belt fastening.

If the driver’s seat belt is not fastened when the ignition switch is turned ON or if it is disconnected after the ignition switch is turned ON, the seat belt warning light will illuminate until the belt is fastened.

If you continue not to fasten the seat belt and you drive over 9 km/h (6 mph), the illuminated warning light will illuminate.

If you continue not to fasten the seat belt and you drive over 20 km/h (12 mph), the seat belt warning chime will sound for approximately 100 seconds and the corresponding warning light will blink.

If you unfasten the seat belt while driving under 20 km/h (12 mph), the seat belt warning light will illuminate until the seat belt is fastened.

Seat belt restraint system
Seat belts are designed to bear upon the bony structure of the body, and should be worn low across the front of the pelvis, chest and shoulders, as applicable; wearing the lap section of the belt ...
Seat belt - Driver's 3-point system with emergency locking retractor
To fasten your seat belt: To fasten your seat belt, pull it out of the retractor and insert the metal tab (1) into the buckle (2). There will be an audible "click" when the tab locks into the b ...
Other information:

Kia Rio 2017-2020 YB Service Manual: Positive Crankcase Ventilation (PCV) Valve


Description and operation Operation Principle Repair procedures Removal 1. Disconnect the vapor hose (A) and then remove the PCV valve (B). Inspection 1. Insert a thin stick (A) into the PCV valve (B) from ...

Kia Rio 2017-2020 YB Owners Manual: Brake/clutch fluid


Checking the brake/clutch fluid level Check the fluid level in the reservoir periodically. The fluid level should be between the MAX (Maximum) and MIN (Minimum) marks on the side of the reservoir. Before removing the reservoir cap and adding brake/clutch fluid, clean the area around the rese ...
Copyright © www.kiamanual.com 2020-2021