Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Alternator: Removal and installation - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Rio UB 2012-2020 Service ManualKia Rio: Alternator: Removal and installation

1.
Disconnect the battery negative terminal first, then the positive terminal.

Tightening torque
(+) terminal :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
(-) terminal (without battery sensor):
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
(-) terminal (with battery sensor):
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)

2.
Remove the drive belt.
(1)
Loosen the through bolt (A).
(2)
Loosen the tension by turning the tension adjusting bolt (B).


(3)
Remove the drive belt (A).


3.
Disconnect the A/C compressor switch connector (A), the alternator connector (B) and the cable from the alternator "B" terminal (C).


4.
Remove the alternator (A).

Tightening torque :
19.6~26.5 Nm (2.0~2.7 kgf.m, 14.5~19.5 Ib-ft)-12mm bolt
29.4~41.2 Nm (3.0~4.2 kgf.m, 21.7~30.4 Ib-ft)-14mm bolt


5.
Installation is the reverse order of removal.
6.
Adjust the alternator belt tension after installation.
Alternator: On-vehicle Inpection
   Check that the battery cables are connected to the correct terminals. ...
Starter: Description
The starting system includes the battery, starter, solenoid switch, inhibitor switch (A/T), ignition switch, ignition lock switch, connection wires and the battery cable. When the ignitio ...
See also:

TPMS Sensor Replacement
Repair tire after using the Tire Mobility Kit (TMK) When the TPMS warning lamp OFF 1. Remove the TMK repaired tire, wheel and TPMS sensor. (Refer to ...

Ambient Temperature Sensor Inspection
1. Turn the ignition switch OFF. 2. Disconnect ambient temperature sensor. 3. Check the resistance of ambient t ...

Side Impact Sensor (SIS) Components
...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts