Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Brake Switch Inspection - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Rio UB 2012-2020 Service ManualKia Rio: Brake Switch Inspection

1.
Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in and when it is released.
2.
The stop lamp switch is in good condition if there is no continuity when plunger (A) is pushed.


Brake Switch Description
The present brake switch is used as an input variable for the ISG function to detect bracke operation. ...
Brake Switch Removal
1. Turn ignition switch OFF. 2. Remove the crash pad lower panel. (Refer to the Body group-"crash pad") 3. ...
See also:

Windshield Wiper-Washer Switch Inspection
Wiper And Washer Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace ...

Fuel Filter Replacement
1. Remove the fuel pump (Refer to “Fuel Pump” in this group). 2. Disconnect the electric pump wiring connector (A) and the fuel sender conn ...

Inspection
1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts