Kia Rio: Compression Pressure Inspection
If there is lack of power, excessive oil consumption or poor fuel
economy, measure the compression pressure.
|
1. |
Make sure the oil in the crankcase is of the correct viscosity
and at the correct level and that the battery is correctly charged.
Operate the vehicle until the engine is at normal operating temperature.
Turn the ignition switch to the OFF position.
|
|
2. |
Remove the engine cover.
|
|
3. |
Disconnect the injector extension connector (A) and the ignition
coil connectors (B).
|
|
4. |
Remove the ignition coils (A).
|
|
5. |
Remove the spark plugs.
Using a 16mm plug wrench, remove the 4 spark plugs.
|
|
6. |
Check the cylinder compression pressure.
|
|
(1) |
Insert a compression gauge into the spark plug hole.
|
|
(2) |
Set the throttle plate in the wide-open position.
|
|
(3) |
While cranking the engine, measure the compression pressure.
Always use a fully charged battery to obtain engine
speed of 250rpm or more.
|
|
(4) |
Repeat step 1) through 3) for each cylinder.
This measurement must be done in as short time
as possible.
|
Compression pressure
Standard : 1225.83 kPa (12.5 kg/cm², 177.79 psi)
(200 ~ 250 rpm)
Minimum : 1078.73 kPa (11.0 kg/cm², 156.46 psi)
Difference between each cylinder :
98kPa (1.0kg/cm², 14psi) or less
|
|
(5) |
If the cylinder compression in one or more cylinders is
low, pour a small amount of engine oil into the cylinder through
the spark plug hole and repeat step 1) through 3) for cylinders
with low compression.
|
| A.
If adding oil helps the compression, it is likely
that the piston rings and/or cylinder bore are worn
or damaged.
|
| B.
If pressure stays low, a valve may be sticking
or seating is improper, or there may be leakage past
the gasket.
|
|
7. |
Install the spark plugs.
Tightening torque :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
|
|
|
8. |
Install the ignition coil.
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
|
9. |
Connect the injector extension connector and the ignition coil
connectors.
|
|
10. |
Install the engine cover.
|
Description
Specifications
Limit
General
Type
In-line, DOHC
Number of cylinders
4
...
Symptom
Suspect area
Remedy
Engine misfire with abnormal internal lower engine noises.
Loose or improperly installed engine flywheel.
Repair or replace ...
See also:
Component(1)
※ Installation order : A → B → C → D → E
1. Steering column shaft
2. Lighting switch
3. Wiper and washer switch
4. Screw
5. Steering angle ...
AVN Head Unit Removal
AVN Head Unit
•
Take care not to scratch the center fascia panel and related
parts.
...
Transaxle Control Module (TCM) Inspection
TCM Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis
ground using the backside of TCM harness connector as TCM side c ...
Specifications
Troubleshooting